Professional flashlight Fenix WF05E with ATEX/IEC certification for use in explosive environments. The flashlight is powered by two AAA batteries and provides up to 85 lumens of light. The flashlight body is made of aluminum alloy for high durability and shock resistance and the clasp is made of antistatic plastic. The flashlight is especially designed for firefighters, rescue workers, use in chemical, petroleum, textile and metallurgical plants and other areas where conventional flashlights cannot be used. It is shaped like a pen and can be carried in a breast pocket. The flashlight is not intended for use in mines.

Certificates:

• Useable in zones 1-2 of explosive gases and in zones 21-22 of explosive dust
• Full text of the certificate:
  • IECEx: Ex ib IIC T4 Gb, Ex ib IIIC T130°C Db IP66/IP68
  • ATEX: II 2G Ex ib IIC T4 Gb, II 2D Ex ib IIIC T130°C Db IP66/IP68
  • CSA: Ex ib IIC T4 Gb IP66/IP68; Class I, Zone 1, AEx ib IIC T4 Gb
    Ex ib IIIC T130°C Db IP66/IP68; Zone 21, AEx ib IIIC T130°C Db IP66/IP68

Flashlight for uses in explosive hazard spaces Fenix WF05E ATEX specifications:

• Powerful Cree XP-G2 LED with 50,000 hours lifetime is used.
• Three power modes: 85 lumens (11.5 hours) -> 30 lumens (35 hours) -> 10 lumens (80 hours).
• Uses two AAA batteries. The manufacturer strongly recommends using only the following battery types that have been certified for use in the flashlight: Energizer E92, Duracell MN2400, and Panasonic LR03XWA
• Protection against accidental insertion of the battery in reverse (reverse polarity).
• Made of aerospace hardened aluminum, durable surface - Type III hard anodized.
• Waterproof and dustproof to IP68 standard.
• Certified for use in explosive gas zones 1-2 and explosive dust zones 21-22.
• Smooth aluminum reflector for a perfect throw with a range of up to 54 meters (724 cd).
• Dimensions 13.45 cm (length) x 1.9 cm (head diameter) x 1.49 cm (body diameter).
• Weight 38 grams (without batteries).
• Included in the package are two Energizer E92 micro alkaline batteries that are approved for use in the flashlight, a spare o-ring and a lanyard.

Use:

To turn the flashlight on, turn the reflector clockwise (tighten the head), the flashlight will always turn on to medium power mode. Turning in the opposite direction turns the flashlight off again (head loosening). To change the brightness, quickly turn the flashlight off and back on from the on state. This will switch the flashlight to the next output level.

Warning

• All servicing and battery replacement should be carried out outside of an explosive atmosphere!
• Never mix batteries of different manufacturers, different ages or different discharge levels.
• When storing batteries for long periods of time, we recommend removing them from the flashlight to prevent them from leaking and damaging the flashlight.
• If the protective rubber rings appear damaged after prolonged use, replace them.
• If the flashlight flickers, does not switch to higher power modes or does not light up, it may be due to one of the following reasons:
  • The batteries are almost dead – replace them.
  • The contacts inside the flashlight are dirty – clean them, for example with a cotton swab.

Warranty

Five years warranty.